Tuesday, December 21, 2010

Changing plugs on 2001 Avalon V6

2002 TOYOTA AVALON SPARK PLUG REPLACEMENT


This information is FYI. The car manual says that the car comes with IRIDIUM Spark Plugs that need changing at 120,000 miles. My car never missed a beat – but at 124,000 I decided to change the plugs. I removed the factory NGK IRIDIUM IFR6A 11 plugs from the engine – all where extremely clean, with some sign of wear on the center electrode. They probably would have lasted a lot longer, however I was glad I pulled them as two were a challenge to loosen up.
I searched out the internet and found:
Original plug NGK IRIDIUM IFR6A 11 no longer available – new part is IFR6T 11
Also listed is the DENSO IK20 (5304) These were about two dollars more (about ten dollars each) – so I bought DENSO plugs.
The front bank is easy – I used a 5/8 inch spark plug wrench with appropriate extenders to unscrew and pull the plugs out of their holes. For replacement – I used a regular long 5/8 inch socket as if you use the spark plug wrench – I couldn’t pull out the socket due to the rubber form in the socket and the extenders would just disconnect leaving the socket attached to the plug.
The rear bank – I reached around from the right side of the engine and pulled loose the rubber hose for the PCV valve(SQUEEZE THE CLAMP WITH OUR FINGERS) . Then remove the PVC valve from the left end of the engine. I also removed two ground wires bolted onto the plate on the end of the intake manifold, plus I unbolted the small assembly connected to the intake manifold plate. These two steps give ample access to removing the rear plugs from the left side and the right side.
While fearing this effort – it turned out to be straight forward and relatively easy. I have put 5,000 miles on these new DENSO plugs – car seems to have more power and I am happy with the change. Total cost was about $60 plus cost of new PCV valve. For those that fall for the dealer saying the plugs need changing at 60k or 90k ----
http://www.tundrasolutions.com/forums/avalon/111461-spark-plug-replacement/
===============
I changed them on my camry V6 a few months ago. I can see why people remove the plenum to get to the right bank but i guess its not impossible if you have the right tools.
Without removing plenum, I found The coil pack on # 4 has to be removed first, the pcv hose too. And there are two wires bolted to the plenum with a nut which are in the way and have to be removed. Then you can access the tough one, #5 plug behind the plenum. I accessed #4 and #5 from the passenger side, leaning on the fender which i covered with a towel first.

Harbor freight has a long long spark plug socket that is tailor made for this and it is $5. I found my sockets are either too long or too short even when used together. Its not fun but can be done.

Re the notorious #5 plug it took me about 30 minutes for this one plug. I used a regular foam insert spark plug socket, one small 3/8" extension and one wobble socket adaptor (which i could have gotten by without, but it made the extension just long enough).

And the most important tip: tape the sockets and extension together so they dont pull apart! I taped them together with duct tape and pulled on them to make sure they would not slip apart. Because the last thing i wanted to be doing is fishing for a spark plug socket back there where you can barely reach.
http://www.toyotanation.com/forum/showthread.php?p=1748838
======================
http://wiki.answers.com/Q/How_to_change_the_3_rear_spark_plugs_for_the_2000_Toyota_Avalon_you_cannot_get_the_one_on_the_right_from_the_passenger_direction_out_because_it_is_blocked_by_the_firewall_when_pulling_plastic_out


To change spark plug first remove coil over connecting clip ensuring to depress connector release. Next remove coil over retaining bolts. Remove coil over carefully directing coil toward driver side until rubber end able to flex out of sparkplug access tube. Remove sparkplug using sparkplug socket with rubber insert. Had to remove ratchet to gain enough clearance. At this point you should be able to remove sparkplug by tilting extension & socket toward drivers side of car. Then lay horizontal & remove toward passenger side of car. If unable to gain access in this manner you probably have too long an extension. Take care as not to damage spark plug coil over as they are considerably expensive.

Thursday, June 3, 2010

2007 Camry brake clunk when starting out

http://www.justanswer.com/questions/1lb1t-purchased-new-2009-se-camry-last-week-right-away-started-having

right away started having noise when brake pedal released. You are stopped with foot on brake pedal, then when you take your foot off the brake pedal to go, the pedal comes up as usual but makes a big thumping/clunking noise as if it is hitting something when it reaches it's final resting position. Read more: http://www.justanswer.com/questions/1lb1t-purchased-new-2009-se-camry-last-week-right-away-started-having#ixzz0pqHFswPm

ABS self check mode, the ABS system runs a "self" check" every time the car is started and makes a "clunk" noise from the front under the hood, this takes place everytime you start the car and make the initial movement, it is also more noticible with colder temperatures Read more: http://www.justanswer.com/questions/1lb1t-purchased-new-2009-se-camry-last-week-right-away-started-having#ixzz0pqGlNogz

All 2009 Camry models come equipped with a standard anti-lock brake system (ABS), Electronic Brake-force Distribution (EBD) and Brake Assist (BA). That means a lot of complex systems trying to work together. There is a TSB (Technical Service Bulletin) for the 2008 model Camry (no bulletins out yet for 2009 model) I would suggest that you make sure the dealer is aware of it. The TSB has to do with the ABS calibration in the braking system, and perhaps there is an adjustment that can be made. The number and description of the TSB is: SB0020-08 MAR 08 ABS/TCS - Zero Point Calibration Information Read more: http://www.justanswer.com/questions/1lb1t-purchased-new-2009-se-camry-last-week-right-away-started-having#ixzz0pqH7pSzH

I get the same thing on mine. Only after the engine is started and you hit about 15 mph. There is something of a "clunk" type sound. But its a system doing an adjustment. The manual even mentions it.Pg 443..."You may hear a click or motor sound in the engine compartment for a few seconds when the engine is started or just after the vehicle begins to move. This means the anti-lock brake system is in the self-check mode, and does not indicate a malfunction".The same kind of paragraph appears in the section that describes VSC etc.If anyone wants to hear this noise, start your engine, lock the doors manually (this eliminates the lock sounds), then start driving. You should hear a "thunk" type sound when you hit about 15 MPH.
http://www.toyotanation.com/forum/showthread.php?t=202157

My wife's 2006 Honda CR-V, and my 2007 Tacoma both do this, only once at initial takeoff. It's the ABS system doing a self-check, don't worry about it.

Yeah I get the clunk at take off, but nothing after that...

ts the VSC/TRAC/ABS self check....it happens once you get over 10 mph or so after every time you start the car.

Friday, March 12, 2010

Ship a car-M2 Reeves $764

Thanks for requesting a quote from M2reeves car shipping.
$819 (After $50 Dollar Mail in Rebate) is our rock-bottom
best door-to-door rate to move your car! In order to schedule
your shipment at the rock bottom lowest price we need several
days notice.
It is important to know that more commonly traveled routes will
pickup faster and less commonly routes slower.
The great part is your credit card is never charged nor is your
check deposited until your car is loaded on the carrier!

Ship a car-Wise auto ship $725

Why Choose Wise Over The Other Guys
» Pay Nothing Until You Are Scheduled For Pickup» Direct Door To Door Service» Over 15 Years Auto Transport Experience» Friendly, Attentive, and Reliable Staff» Open 7 Days a Week» Accredited by The BBB» 5 Star Rated by TransportReviews.com» Open And Enclosed Carriers» 100% Licensed, Bonded and Insured

Shipping a car-Total Car $850

As a reminder, the price quote to ship your 2007 Toyota Camry from Bearsdale, IL to Emeryville, CA is $850.
*IMPORTANT INFO: PICK UP(s)ARE AVERAGING 3 DAYS ONLY* Call me today to set up your FREE reservation. NO DEPOSIT REQUIRED upfront.
If the vehicle is not availble now you can call TODAY to reserve your date.
My name is SARAH and I will be assisting you with your transport. I understand how customers want to conduct business and we have a great track record in helping them accomplish their goals..
This is an ALL INCLUSIVE which means this price includes all taxes, tolls, fuel, 100% Insurance, Door to Door Shipping, and Direct Service (one truck one driver all the way) there will be no additional charges. I will also provide you with a FREE ONLINE TRACKING SYSTEM.

Shipping a car-All Auto Trust $599

We just want to let you know we called you today and left a message to follow-up on your inquiry for a price quote to ship your 2007 Toyota Camry on Open carrier from Bearsdale, IL to Emeryville, CA is $599.
we want you to choose the right company.by making an educated decision you can check us out in transportreviews.com and we are with the BBB Rated a B+ .dont let other companies rip you out of a deposit!
If you have any questions, don't hesitate to call us at 888-846-5564, or email Ryan.aattransport@gmail.com.

Shipping a car-A Across USA $775

Thank you for your interest in Across USA Auto Transport. My name is Ryan and I would be happy to answer any questions you might have concerning your vehicle tranport. Our toll free number is 800-243-0066. Just ask for Ryan. Our rate to ship your 2007 Toyota Camry in an Open car carrier is $775. This price includes door to door service and full insurance with zero deductible. We are a family owned and operated transport brokerage. Simply put, we find a reliable transporter that will move your vehicle in an efficient manner. We are in our 18th year in business and have continued to grow each year. A large part of our business is from referrals and repeat customers. We must be doing something right! Before you decide on which transporter to use, please read the following:
Did you know that over 10,000 vehicles are past their scheduled pick up date right now? The reason is that the rates are not high enough to attract any carrier to move them. Don't be fooled by false claims, misleading gas card rewards, or extremely low rates. Many brokers move less than 50% of their orders. We move over 95% of our orders. There are a lot of good auto transport companies, but there are also a lot of bad ones. Make sure you select a good one. We are members of the Better Business Bureau. Please check with them before you choose a transporter.